12V 3mm Yellow LED Built in Resistor DC

Can LED Lights run on 12V? 

Sure~ Common Yellow LED just got the voltage range in 1.9-2.4V. But if you make it work on 12 Volt, the yellow LED light will burn. If we have to need this LED to work on 12 volt, people need to add some resistor into the circuit or add some IC into the LED light. please check with this 12V 3mm Round Top LED in Yellow Diffused LED. If you tired of pre-wire the resistor and looking for some 12V Light Emitting Diode that can intall directly? 304FYD59D3L14V12 was born for your project. As you can see the picture for this 12V Yellow LED, it looks the same with common yellow LED Lamps. Compare with common 590nm ELD, there have an built in resistor inside of the diffused yellow lens. That's the little thing inside to make LED Lamps got high voltage. After you pass the 12V forward voltage to this LED, it will light up as the same Super Bright LED Lamps, which is diffused, yellow and bright. Same as other LED, this lens of LED type are also available in water clear, yellow clear or milky lens. Just contact us for more detail about it~

Dimension of 3mm through-hole LED:

Through-hole LED Features: 

* Dimension of Lens: 3mm round top;

* Forward voltage: 12VDC Compatible;

* Wavelength 590nm;

* Lens type: Yellow diffused;

* High reliability and high radiation intersity;

Electrical Parameters:

* Pulse forward current condition: Duty 1% and pulse width=10us.

* Soldering condition: Soldering condition must be completed with 3 secongds at 260℃

Electrucal Optical Characteristics(Tc=25℃)

*Luminous Intensity is measured by ZWL600.

*θ1/2 is off-sxis angle at which the luminous intenity is half the axia luminous intensity;