IR 810nm LED Emitter 2016 SMD LED

What color are IR LEDs? 

In LED industry, we usually call those SMD LED or through-hole LED with wavelength over 680nm as Infrared LED( IR LED ). In this 2016FIRC-81L14I100, there are 810nm LED wavelength inside the SMD LED package. We will name it as 810nm IR LED at the same. 365nm LED emits purple color, 460nm LED emits blue color, 520nm LED emits green color...Then what is the color of IR LED? Actually it's dim and deep red color. 635nm LED is a red LED that you will see in the traffic light when we walk into the street. 660Nm LED will got a deeper red color than that. The longer wavelength, the color gets more deep and dim. Until you cannot even see the light when the LED it's working. 

Electrical Parameters:

*Pulse forward current confition: Duty 1% and Pulse width=10us.

*Soldering confition: Soldering confition must be completed with 3 secongds at 260℃

*Luminous intensity is measured by ZWL600.

*λD is derived from the CIE chromaticity diagram and represents the single wavelength which defines the color of the device.

Size of 810nm LED with 2016 SMD LED: 

Product Details: 

99.99% purity gold wire;

Silver plated LED frame;

Famous branded chips;

High quality epoxy;

Production progress: 

HANDLING PRECAUTIONS:

Compare to epoxy encapsulant that is hard and brittle, silicone is softer and flexible Althouth its characteristiec significantly reduces thermal stress, it is more susceptible to damage by extemal mechanical force. As a result, special handling precautions need to be observed during assembly using silicone encapsulated Led products. Failure to comply might lead to damage and premature failure of the led

1. Handle the component along the side surfaces by using forceps or appropriate tools.

2, Do not directly touch or handle the silicone lens surface. It may damage the internal circuitry.

3, Do not stack together assembled PCBS containing exposed LEDs. Impact may scratch the silicone lens or damage the internal circuitry.

4, 4-A The inner diameter of the SMD pickup nozzle should not exceed the size of the LED to prevent air leaks;

    4-B A plible material is suggested for the nozzle tip to avoid acratching or damaging the LED surface during pickup.

    4-C The dimension of the component must be accurately programmed in the pick-and-place machine to insure precise pickup and avoid damage during production;

    4-D As silicone encapsulation is permeable to gases, some corrosive substances such as H2S might corrode silver plationg of leadframe. Special care should be taken if an LED with silicone encapsulation is to used near such substances. 

5, Please aviod continued exposure to the condensing moisture environment and keep the product away from repid transitions in ambiemt temperature.

6, Product in the original sealed package is recommended to be assembled within 24 hours of opening.