Cyan 3 Chips blue 5050 SMD LED PLCC 6;

5050 SMD LED frame can be package with different color in side. For example, there can be three chips 625nm LED in side, 520nm LED inside or RGB LED inside. In this 5050UBC48DL12, we produce it with 3 chips 480nm LED cyan SMD LED . There have 6 pads on the bottom of 5050 SMD LED, each 2 pad can control one color normally. In this case, there are 3 same chips inside. Each chip can handle 20mA operation current. When you light up the LED with 6 pins, this LED will be able to handle 60mA operation current. Which will be more bright than 1 single chip. Do you need some 5050 SMD LED with cyan blue LED color for your project? If so, just contact us for more detail about it~

5050 SMD LED Dimension Parameters

         These SMD LED case are also available for  IR LED , UV LED , Blue SMD LED, Red Smd Led, Amber LED ect.

Handling Precautions:

Compare to epoxy encapsulant that is hard and brittle, silicone is softer and flexible Althouth its characteristiec significantly reduces thermal stress, it is more susceptible to damage by extemal mechanical force. As a result, special handling precautions need to be observed during assembly using silicone encapsulated Led products. Failure to comply might lead to damage and premature failure of the led

1. Handle the component along the side surfaces by using forceps or appropriate tools.

2, Do not directly touch or handle the silicone lens surface. It may damage the internal circuitry.

3, Do not stack together assembled PCBS containing exposed LEDs. Impact may scratch the silicone lens or damage the internal circuitry.

4, 4-A The inner diameter of the SMD pickup nozzle should not exceed the size of the LED to prevent air leaks;

    4-B A plible material is suggested for the nozzle tip to avoid acratching or damaging the LED surface during pickup.

    4-C The dimension of the component must be accurately programmed in the pick-and-place machine to insure precise pickup and avoid damage during production;

    4-D As silicone encapsulation is permeable to gases, some corrosive substances such as H2S might corrode silver plationg of leadframe. Special care should be taken if an LED with silicone encapsulation is to used near such substances. 

5, Please aviod continued exposure to the condensing moisture environment and keep the product away from repid transitions in ambiemt temperature.

6, Product in the original sealed package is recommended to be assembled within 24 hours of opening.