Green LEDs SMT 3535 High Power LEDs

High Power Green LED with 3535 SMD LED Domed Lens

If you need high power 3535 SMD LED with green 520nm LED wavelength in your project, both 3535LGC52D140L38 and 3535LGC-52D40L28 are good choice for the lighting project. But when your max operation currect just 350mA or even smaller. Then 3535LGC-52D40L28 might be a better way to save the cost and energy. It can reach brightness at range of 35-50lm when you pass the 350mA operation current to it. 

On the other hand, this SMD LED got the same package with 3535LGC-52D40L38, due to the domed lens on the top, this Green Smd LED will emits the super bright light for your project. Just feel free to contact us if you need more information about this Green SMD LED. 

Size of 3535 Green SMD LED:

Electrical Parameters:

*Pulse forward current confition: Duty 1% and Pulse width=10us.

*Soldering confition: Soldering confition must be completed with 3 secongds at 260℃

*Luminous intensity is measured by ZWL600.

*λD is derived from the CIE chromaticity diagram and represents the single wavelength which defines the color of the device.

Product detail:

Are you wondering what's the material inside for connection for this LED? There are some detail as follow: 

HANDLING PRECAUTIONS:

Compare to epoxy encapsulant that is hard and brittle, silicone is softer and flexible Althouth its characteristiec significantly reduces thermal stress, it is more susceptible to damage by extemal mechanical force. As a result, special handling precautions need to be observed during assembly using silicone encapsulated Led products. Failure to comply might lead to damage and premature failure of the led

1. Handle the component along the side surfaces by using forceps or appropriate tools.

2, Do not directly touch or handle the silicone lens surface. It may damage the internal circuitry.

3, Do not stack together assembled PCBS containing exposed LEDs. Impact may scratch the silicone lens or damage the internal circuitry.

4, 4-A The inner diameter of the SMD pickup nozzle should not exceed the size of the LED to prevent air leaks;

    4-B A plible material is suggested for the nozzle tip to avoid acratching or damaging the LED surface during pickup.

    4-C The dimension of the component must be accurately programmed in the pick-and-place machine to insure precise pickup and avoid damage during production;

    4-D As silicone encapsulation is permeable to gases, some corrosive substances such as H2S might corrode silver plationg of leadframe. Special care should be taken if an LED with silicone encapsulation is to used near such substances.

5, Please aviod continued exposure to the condensing moisture environment and keep the product away from repid transitions in ambiemt temperature.

6, Product in the original sealed package is recommended to be assembled within 24 hours of opening.