Blue LEDs SMD LED with SMT 3535 LED

3W High Power SMT 3535 LED with 480mn LED

3535PBC48D60L45 is a high power blue LED with 3535 SMD LED case. Because of there have a domed lens on the surface of SMD LED , you can also name this as high power Dome lens SMD LED. Normally the Blue SMD LED (or through-hole LED) will emits 470nm LED or 450nm royal blue color. 480nm will be more close to 520nm green color, so that the 480nm color will be more light water blue. It's lighter than 470nm or 460nm deep blue LED. Compare with other blue LED, this 480nm blue light wavelength is kind of special and not easy to see. In this product, we package it with 3535 Blue SMD LED case and produce it with high power chip. You can easy to drive this light up with even small operation current. At the same time, when you need more higher brightness or output, just feel free to increase the current, it can handle 700mA current and emits 50-70lm at that time. 

If you were looking for High Power LED with blue color, this one won't let you down~ 

Size of 3535 Blue SMD LED:

Electrical Parameters:

*Pulse forward current confition: Duty 1% and Pulse width=10us.

*Soldering confition: Soldering confition must be completed with 3 secongds at 260℃

*Luminous intensity is measured by ZWL600.

*λD is derived from the CIE chromaticity diagram and represents the single wavelength which defines the color of the device.

In order to make sure all our customer can get the perfect performance from this 480nm LED with high power 3535 case, we produce this high power LED with stable brand new chip, caremic LED frame, high quality epoxy for the lens and pure gold wire for the inside connection. 

Application:

HANDLING PRECAUTIONS:

Compare to epoxy encapsulant that is hard and brittle, silicone is softer and flexible Althouth its characteristiec significantly reduces thermal stress, it is more susceptible to damage by extemal mechanical force. As a result, special handling precautions need to be observed during assembly using silicone encapsulated Led products. Failure to comply might lead to damage and premature failure of the led

1. Handle the component along the side surfaces by using forceps or appropriate tools.

2, Do not directly touch or handle the silicone lens surface. It may damage the internal circuitry.

3, Do not stack together assembled PCBS containing exposed LEDs. Impact may scratch the silicone lens or damage the internal circuitry.

4, 4-A The inner diameter of the SMD pickup nozzle should not exceed the size of the LED to prevent air leaks;

    4-B A plible material is suggested for the nozzle tip to avoid acratching or damaging the LED surface during pickup.

    4-C The dimension of the component must be accurately programmed in the pick-and-place machine to insure precise pickup and avoid damage during production;

    4-D As silicone encapsulation is permeable to gases, some corrosive substances such as H2S might corrode silver plationg of leadframe. Special care should be taken if an LED with silicone encapsulation is to used near such substances.

5, Please aviod continued exposure to the condensing moisture environment and keep the product away from repid transitions in ambiemt temperature.

6, Product in the original sealed package is recommended to be assembled within 24 hours of opening.