2835 Dome Lens SMD LED Orange LED 15-degree

Dome lens SMD 600nm - 610nm LED ;

Compare with SMD LED , normally through-hole LED Lamps will have higher brightness because its epoxy lens will increase the brightness when it's working. However, SMD LED also has its own advantages. Obviously, 2835 SMD LED has better heat dissipation than 5mm Through-hole LED. In this case, there are the Dome lens SMD LED. Which combine the advantages of both: a lens that can amplify brightness and a package type with good heat dissipation. If you looking for some Orange LED with longer lifespan and high brightness, check this 2835FOC61D3L14A15 out~

Electrical Parameters:

*Pulse forward current confition: Duty 1% and Pulse width=10us.

*Soldering confition: Soldering confition must be completed with 3 secongds at 260℃

Domed Lens SMD LED Size of  Turquoise LED:  

HANDLING PRECAUTIONS:

Compare to epoxy encapsulant that is hard and brittle, silicone is softer and flexible Althouth its characteristiec significantly reduces thermal stress, it is more susceptible to damage by extemal mechanical force. As a result, special handling precautions need to be observed during assembly using silicone encapsulated Led products. Failure to comply might lead to damage and premature failure of the led

1. Handle the component along the side surfaces by using forceps or appropriate tools.

2, Do not directly touch or handle the silicone lens surface. It may damage the internal circuitry.

3, Do not stack together assembled PCBS containing exposed LEDs. Impact may scratch the silicone lens or damage the internal circuitry.

4, 4-A The inner diameter of the SMD pickup nozzle should not exceed the size of the LED to prevent air leaks;

4-B A plible material is suggested for the nozzle tip to avoid acratching or damaging the LED surface during pickup.

4-C The dimension of the component must be accurately programmed in the pick-and-place machine to insure precise pickup and avoid damage during production;

4-D As silicone encapsulation is permeable to gases, some corrosive substances such as H2S might corrode silver plationg of leadframe. Special care should be taken if an LED with silicone encapsulation is to used near such substances.

5, Please aviod continued exposure to the condensing moisture environment and keep the product away from repid transitions in ambiemt temperature.

6, Product in the original sealed package is recommended to be assembled within 24 hours of opening.