1450nm IR LED 0.4W 2835 SMD Package

1400nm Far Red IR LED with 2 chips inside;

If 3W output is too strong for you and 0.2W output is too small for your project, just check with this 2835IRC1407I400-2P. We produce this 1400nm LED with 2835 SMD LED. In order to reach higher output, we also put 2 chips inside the SMD LED package. Once the current pass the LED, both of these chip inside will be light up and work at the same time. With 2 chips inside, this 2835 IR LED will be able to handle higher operation current than 1 chip. This package way(surface mount) will make sure this LED got a better heat dissipation performance and wider viewing angle. Which means this IR LED will got stable performance, longer lifespan and bigger radiation area than through-hole package type. 

Contact us for more detail. 

1400nm IR LED Product Size: 

*This LED frame size are also available in UV LED , Yellow LED, Green Smd LED, Blue SMD LED and Red Smd Led ect*

HANDLING PRECAUTIONS:

Compare to epoxy encapsulant that is hard and brittle, silicone is softer and flexible Althouth its characteristiec significantly reduces thermal stress, it is more susceptible to damage by extemal mechanical force. As a result, special handling precautions need to be observed during assembly using silicone encapsulated Led products. Failure to comply might lead to damage and premature failure of the led

1. Handle the component along the side surfaces by using forceps or appropriate tools.

2, Do not directly touch or handle the silicone lens surface. It may damage the internal circuitry.

3, Do not stack together assembled PCBS containing exposed LEDs. Impact may scratch the silicone lens or damage the internal circuitry.

4, 4-A The inner diameter of the SMD pickup nozzle should not exceed the size of the LED to prevent air leaks;

    4-B A plible material is suggested for the nozzle tip to avoid acratching or damaging the LED surface during pickup.

    4-C The dimension of the component must be accurately programmed in the pick-and-place machine to insure precise pickup and avoid damage during production;

    4-D As silicone encapsulation is permeable to gases, some corrosive substances such as H2S might corrode silver plationg of leadframe. Special care should be taken if an LED with silicone encapsulation is to used near such substances. 

5, Please aviod continued exposure to the condensing moisture environment and keep the product away from repid transitions in ambiemt temperature.

6, Product in the original sealed package is recommended to be assembled within 24 hours of opening.