1200nm 1250nm LED Far Red Infrared 2835 SMD

2 chips 1200nm LED with 2835 SMD LED PLCC2 Case;

The wavelength over than 1000nm or 1050nm LED are Far red infrared LED. Different with 850nm LED , this 1200nm LED is far red IR LED , which means it cannot as bright as 850nm LED when it's working. On the other hand, because of 1200nm chip is a small power LED chip, in order to increase the radiation, we package 2835IRC120L7I400-2P with 2 chips inside. Both of these little chip will work at the the same time as long as electric pass through the SMD LED . Compare with one single chip LED, this double chip LED will got two times of radiation when it's working. If 3w High Power IR LED 1200nm Infrared LED are too much for your application and 0.2W 1200nm LED is too weak for your project, give it a shot with this 2 chips 2835 SMD LED type. 

Product Size: 

*This LED frame size are also available in UV LED , Yellow LED, Green Smd LED, Blue SMD LED and Red Smd Led ect*

HANDLING PRECAUTIONS:

Compare to epoxy encapsulant that is hard and brittle, silicone is softer and flexible Althouth its characteristiec significantly reduces thermal stress, it is more susceptible to damage by extemal mechanical force. As a result, special handling precautions need to be observed during assembly using silicone encapsulated Led products. Failure to comply might lead to damage and premature failure of the led

1. Handle the component along the side surfaces by using forceps or appropriate tools.

2, Do not directly touch or handle the silicone lens surface. It may damage the internal circuitry.

3, Do not stack together assembled PCBS containing exposed LEDs. Impact may scratch the silicone lens or damage the internal circuitry.

4, 4-A The inner diameter of the SMD pickup nozzle should not exceed the size of the LED to prevent air leaks;

4-B A plible material is suggested for the nozzle tip to avoid acratching or damaging the LED surface during pickup.

4-C The dimension of the component must be accurately programmed in the pick-and-place machine to insure precise pickup and avoid damage during production;

4-D As silicone encapsulation is permeable to gases, some corrosive substances such as H2S might corrode silver plationg of leadframe. Special care should be taken if an LED with silicone encapsulation is to used near such substances.

5, Please aviod continued exposure to the condensing moisture environment and keep the product away from repid transitions in ambiemt temperature.

6, Product in the original sealed package is recommended to be assembled within 24 hours of opening.