1200nm LED IR Receiver 5050 SMD Package

Far Red Smd Led with 5050 SMD package size;

This 5054SMD-PD-1mm is a high speed and high sensitive photodiode in a standard 5054 SMD package. This device is sensitiver to infrared radiation, even the 1050nm LED, 1200nm LED ect. IR Receiver can be widely use in monitoring, fiber-opti instruments and data communications project. At the same time, 5050 SMD LED type got a bigger size and bigger heat sink in the bottom so that this photodiode can be much more easy to dispatching the extra heat when it's working. 

HANDLING PRECAUTIONS:

Compare to epoxy encapsulant that is hard and brittle, silicone is softer and flexible Althouth its characteristiec significantly reduces thermal stress, it is more susceptible to damage by extemal mechanical force. As a result, special handling precautions need to be observed during assembly using silicone encapsulated Led products. Failure to comply might lead to damage and premature failure of the led

1. Handle the component along the side surfaces by using forceps or appropriate tools.

2, Do not directly touch or handle the silicone lens surface. It may damage the internal circuitry.

3, Do not stack together assembled PCBS containing exposed LEDs. Impact may scratch the silicone lens or damage the internal circuitry.

4, 4-A The inner diameter of the SMD pickup nozzle should not exceed the size of the LED to prevent air leaks;

4-B A plible material is suggested for the nozzle tip to avoid acratching or damaging the LED surface during pickup.

4-C The dimension of the component must be accurately programmed in the pick-and-place machine to insure precise pickup and avoid damage during production;

4-D As silicone encapsulation is permeable to gases, some corrosive substances such as H2S might corrode silver plationg of leadframe. Special care should be taken if an LED with silicone encapsulation is to used near such substances.

5, Please aviod continued exposure to the condensing moisture environment and keep the product away from repid transitions in ambiemt temperature.

6, Product in the original sealed package is recommended to be assembled within 24 hours of opening.