Super Bright 10mm Blue LED Bulb Clear Lens

10mm LED Blub Blue Color with Clear Lens

As we know through-hole LED Lamps can be priduce with different size. In this 1004BC-12, we produce it with 10mm Blue Through-Hole LED in clear lens. With this clear lens, the brightness will be much more easy to emit from the middle and the brightness mcd will also be increase by the lens. Same with the other Blue Through-hole LED, the positive mark of this 10mm Blue Through-hole LED is marked by the longer LED pin. And the cathode is marked by the shorter pin. When we pass the current can light this 470nm LED up, the current flows will come from the anode and to the cathode. 

This Super Bright LED Lamps are easy to use in kind of lighting project or DIY project. 1004BC-12 can handle 30mA operation current, but it can be light up even the current just 1mA. In this case, the brightness of blue LED can be easy to control by the current, increase the working current, you will get more brightness and when you mae it down, the brightness will be dim. 

If you want to know more detail for this 10mm LED bulb, just feel free to contact us~

Storage Conditions: 

1. avoid continued exposure to the condensing moisture environment and keep the product away from rapid transitions in ambient temperature;

2. LEDs should be stored with temperature ≤30℃ and relative humidity<60%℃;

3. Product in the original sealed package is recommended to be assembled within 72 hours of opening;

4. Product in opened package for more than a week should be baked for 6-8 hours at 85-10℃;

LED MOUNTING METHOD

1, The lead pitch of the LED must match the pitch of the mounting holes on the PCB during component placement;

Lead-forming may be required to insure the lead pitch matches the hole pitch;

Refer to the figure below for proper lead forming procedures;

Do not route PCB trace in the contact area between the leadframe and the PCB to prevent short-circuits;

Noted:

○ Correct mounting method;

× Incorrect mounting method;

2. When soldering wires to the LED, each wire joint should be separately insulated with heat-shrink tube to prevent short-circuit contact.

Do not bundle both wires in one heat shrink tube to avoid pinching the LED leads;

Pinching stress on the led leads may damage the internal structures and cause failure;

Noted:

○ Correct mounting method;

× Incorrect mounting method;

3. Use stand-offs(Fig 3)or spacers(Fig 4)to securely position the LED above the PCB;

4. Maintain a minimum of 3mm clearance between the base of the LED lens and the first lead bend (Fig. 5. Fig. 6)

5. During lead forming, use tools or jigs to hold the leads securely so that the bending force will not be transmitted to the LED lens and its internal structures;

Do not perform lead forming once the component has been mounted onto the PCB;

Lead Forming Procedures

1. Lead Forming Procedures;

2. Do not bend the leads more than twice (Fig. 7);

3. During soldering, component covers and holders should leave clearance to avoid placing damaging stress on the LED during soldering(Fig 8);

4. The tip of the soldering iron should never touch the lens epoxy;

5. Through-hole LEDs are incompatible with reflow soldering;

6. If the LED will undergo multiple soldering passes or face other processes where the part may be subjected to intense heat please check with Best LED for compatibility;